The Report Submission form may be used to submit a report on a project fabricated through MOSIS. These reports help us monitor the quality of fabricated parts.

DESIGN-NUMBER

The unique 5-digit or 6-digit design number assigned by MOSIS when the project was created using the New Project Form. This number is returned in the response to a successful new project creation.

DESIGN-PASSWORD

The password you chose for your project when you created it with the New Project request.

FAB-ID

The fabrication id of your project. When a design is placed on a fabrication run, it is assigned a Fab ID, which identifies a particular fabrication of a design. If you ask MOSIS to refabricate your design on additional fabrication runs, you will receive a new Fab ID for each refabrication. The Fab ID (such as "N11XAB") consists of two parts:

• a four-character Run ID which identifies the wafer fabrication run ("N11X")
• a two-letter Die ID which identifies your design on the run ("AB").

The Fab Id is reported to you in the e-mail notification sent when your project goes into fabrication and on the notification sent when your project is shipped.

DESIGN-TYPE

The design type of your project (Digital, Analog, Mixed-Signal, etc).

SUBMITTER

The name of the person submitting the report. If you are submitting the report on behalf of someone else (e.g., an administrative assistant submitting a report for a university professor), you should use the name of the person for whom you are submitting the report.

EMAIL-ADDRESS

The e-mail address of the person submitting the report. If you are submitting the report on behalf of someone else (e.g., an administrative assistant submitting a report for a university professor), you should use the e-mail address of the person for whom you are submitting the report.

NUMBER-PARTS-RECEIVED

The number of fabricated IC parts you received for this project. You should count all parts received, both packaged and unpackaged, regardless of whether they were received in one shipment or in multiple shipments.

NUMBER-PARTS-TESTED

The number of parts tested to determine whether they worked as expected.

NUMBER-PARTS-FUNCTIONAL

The number of parts which were tested and worked as expected.

PART-SPEED

The measured speed of the parts. Leave blank if not applicable to your project.

FAILURE-CAUSES

The reason(s) your parts failed or did not work as expected. If you're not sure of the reasons, give your best guess. Leave blank if your parts worked as expected.

COMMENTS

Any additional comments you want to make about your design or the quality of the parts you received from MOSIS.

PROJECT-URL

The URL for the web site for your project. Leave blank if none.